Brocade Communications Systems LS-STK Guide d'installation télécharger pdf (Page 33)

Brocade FastIron LS and FastIron LS-STK Hardware Installation Guide 23

53-1002187-01

Installing a redundant power supply

DRAFT: BROCADE CONFIDENTIAL

5. To connect additional RPS devices, first disconnect the original RPS device from the AC power

supply, then follow steps 1, 2, 4 and 5.

DANGER

Once the RPS device is disconnected from the AC power supply, the RPS device will no longer

provide redundant power until after the additional RPS devices are installed, the AC power is

reconnected, and the RPS device completes the self-test procedure.

6. Check the LEDs on the RPS device to ensure proper operation. The Power LED should light up.

If it does not light, see Chapter 6, “Troubleshooting” for more information.

NOTE

For International use, you may need to change the AC power cable. You must use a power cable that

has been approved for the receptacle type in your country.

1RPS Input Port 4 FLS Units

2 AC Power Supply Number 1 5 RPS Output Port

3 RPS Unit 6 AC Power Supply Number 2

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 93 94

Pas de commentaire

Brocade Communications Systems LS-STK Guide d'installation Page 33