Brocade Communications Systems Gateway Manuel de service télécharger pdf (Page 40)

4-8 Access Gateway Administrator’s Guide

Publication Number: 53-1000430-01

Managing the failover and failback policies

Enabling the failback policy

A switch in Access Gateway mode supports automatic F_Port failback to N_Ports when that port comes

back online. By default the failback policy is enabled.

When an N_Port with an enabled failback policy comes back online, the F_Ports that were originally

mapped to it are automatically rerouted back to the N_Port.

To enable failback

1. Connect and log in to the switch.

2. Enter the ag --failbackshow command with the n_portnumber operand to display the failover

setting.

3. Enter the ag --failbackenable command with the n_portnumber operand to enable failover.

To disable failback

1. Connect and log in to the switch.

2. Enter the ag --failbackshow command with the n_portnumber operand to display the failover

setting.

3. Enter the ag --failbackdisable command with the n_portnumber operand to disable failover.

switch:admin> ag --failbackshow 13

Failback on N_Port 13 is not supported

switch:admin> ag --failbackenable 13

Failback policy is enabled for port 133

switch:admin> ag --failbackshow 13

Failback on N_Port 13 is supported

switch:admin> ag --failbackdisable 13

Failback policy is disabled for port 13

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 61 62

Pas de commentaire

Brocade Communications Systems Gateway Manuel de service Page 40