Brocade-communications-systems Brocade MLX Series and Brocade Netlron XMR 53-1002 Manuel d'utilisateur télécharger pdf (Page 373)

Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide 355

53-1002373-02

Replacing a power supply

NOTE

A threshold value of 0 will not automatically shutdown a power supply due to failures.

For Syslog messages, please refer to Appendix A, Using Syslog in the Brocade MLX Series and

Brocade NetIron Family Configuration Guide.

Clearing power supply failure timestamps

Use the power-supply monitoring clear command to clear all collected failure timestamps for a

given power supply, or for all available power supplies.

To clear all collected failure timestamps for a power supply, enter the following command.

Brocade(config)# power-supply monitoring clear 1

This will clear all collected failure timestamps for the Power Supply # 1

Are you sure? (enter 'y' or 'n'): y

To clear all collected failure timestamps for all available power supplies, enter the following

command.

Brocade(config)# power-supply monitoring clear all

This will clear all collected failure timestamps for all available Power Supplies

Are you sure? (enter 'y' or 'n'): y

You are asked to verify this command by entering “yes” or “no.

Syntax: power-supply monitoring clear <decimal | all>]

By default, no power-supply monitoring is configured.

The <decimal> variable specifies a power supply number, The all keyword clears all available power

supplies.

Displaying power supply monitoring timestamps

To display timestamps for failures on any power supply, enter the following command.

Brocade# show power-supply-monitoring

PS-1 PS-2 PS-3 PS-4 PS-5 PS-6 PS-7 PS-8

1 ) 0 0 0 0 0 0 0 0

2 ) 0 0 0 0 0 0 0 0

3 ) 0 0 0 0 0 0 0 0

4 ) 0 0 0 0 0 0 0 0

5 ) 0 0 0 0 0 0 0 0

6 ) 0 0 0 0 0 0 0 0

7 ) 0 0 0 0 0 0 0 0

8 ) 0 0 0 0 0 0 0 0

9 ) 0 0 0 0 0 0 0 0

The show power-supply-monitoring command displays the last 32 recorded failure timestamps for

a power supply. The current configured power supply monitoring threshold value is also displayed

at the end of the output.

Syntax: show power-supply-monitoring

1 2 ... 368 369 370 371 372 373 374 375 376 377 378 ... 451 452

Pas de commentaire

Brocade-communications-systems Brocade MLX Series and Brocade Netlron XMR 53-1002 Manuel d'utilisateur Page 373