Brocade-communications-systems Brocade MLX Series and Brocade Netlron XMR 53-1002 Manuel d'utilisateur télécharger pdf (Page 386)

100

101

368 Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide

53-1002373-02

Replacing fan assemblies

You can replace the air filters while a router is powered on and running. Before performing this

task, have these items available:

• A 7/64 inch hex head screwdriver

• Replacement air filters, which you can order from Brocade

Replacing the air filters in 32-slot routers

The two air filters in 32-slot routers are located between the upper and lower card cages. To replace

an air filter, perform these steps.

NOTE

Air filters for 32-slot routers are marked with a directional arrow to indicate proper alignment for the

direction of airflow in the device. The upper filter should be inserted with the arrow pointing up, and

the lower filter should be inserted with the arrow pointing down.

1. From the front of the router, remove the air inlet cover by unscrewing the four captive screws

with a 7/64 inch hex head screwdriver, as shown in Figure 239.

FIGURE 239 32-slot router air inlet panel.

2. Remove the old air filter by pulling it straight out from the router, as shown in Figure 240.

3. Insert a new filter, being careful that it aligns within the narrow channel.

4. Repeat steps 2 and 3 to replace the second filter.

5. Replace the air inlet cover and tighten the four captive screws to secure the air filter to the

router.

1Captive screws

Pwr

Active

Pwr

Active

Pwr

Active

Pwr

Active

1 1

1 2 ... 381 382 383 384 385 386 387 388 389 390 391 ... 451 452

Commentaires sur ces manuels

Pas de commentaire

Brocade-communications-systems Brocade MLX Series and Brocade Netlron XMR 53-1002 Manuel d'utilisateur Page 386

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Brocade-communications-systems Brocade MLX Series and Brocade Netlron XMR 53-1002